........................................................................................................................................................................................................................................................................................................................................................................... ....................
工作程序:
1、工作前先接通水電,放水清理水床,將水床中余水放干;
2、將排水開關關閉,調好冷熱水溫,開始對水床放水,水量必須超出按摩噴咀,方能啟動水泵電機啟動開關,此時按摩噴咀開始噴射出水;
3、當水床中水量下降至按摩噴咀下2、3cm時,必須打開進水開關,一邊加水,一邊噴射按摩,避免因缺水而損壞水泵電機;
4、每用完一次水療床,請將水床排水閥打開,放完余水,并放水清潔,清洗完畢即關閉水源及排水閥,以備下次使用。
三、技術指標
使用電壓:220V
功率:1匹(750W)
規格:2150×1050×650mm
警 示
1、嚴禁在水療床水位不夠時啟動按摩水泵電機,以免抽空缺水而燒毀電機;
2、電源接地線必須可靠接地,接地地阻小于10歐姆,嚴禁將電源接地線接在水療床鐵架上
.........................................................................................................................................................................................................................................................................................................................................................................................................................................................