InvenSense ICM-20600，6軸陀螺儀

InvenSense、Qorvo、AKM、Goertech、AMS、Easybond一級代理

所有物料為全新日期原包裝，有售后支持。詳情請咨詢陳先生

如需產品手冊，及技術支持，請聯系陳先生

PURPOSE AND SCOPE
    This document is a product specification, providing a description, specifications, and design related information on the ICM-20600? MotionTracking device. The device is housed in a small 2.5x3x0.91mm 14-pin LGA package.

PRODUCT OVERVIEW
    The ICM-20600 is a 6-axis MotionTracking device that combines a 3-axis gyroscope, and a 3-axis accelerometer in a small 2.5x3x0.91mm (14-pin LGA) package. It also features a 1K-byte FIFO that can lower the traffic on the serial bus interface, and reduce power consumption by allowing the system processor to burst read sensor data and then go into a low-power mode. ICM-20600, with its 6-axis integration, enables manufacturers to eliminate the costly and complex selection, qualification, and system level integration of discrete devices, guarantee eing optimal motion performance for consumers.
    The gyroscope has a programmable full-scale range of ±250, ±500, ±1000, and ±2000 degrees/sec. The accelerometer has a user-programmable accelerometer full-scale range of ±2g, ±4g, ±8g, and ±16g. Factory-calibrated initial sensitivity of both sensors reduces production-line calibration requirements.
    Other industry-leading features include on-chip 16-bit ADCs, programmable digital filters, temperature sensor, and programmable interrupts. The device features I2C and SPI serial interfaces, a VDD operating range of 1.71 to 3.45V, and a separate digital IO supply, VDDIO from 1.71V to 3.45V.
    Communication with all registers of the device is performed using either I2C at 400kHz or SPI at 10MHz.
    By leveraging its patented and volume-proven CMOS-MEMS fabrication platform, which integrates MEMS wafers with companion CMOS electronics through wafer-level bonding, InvenSense has driven the package size down to a footprint and thickness of 2.5x3x0.91mm (14-pin LGA), to provide a very small yet high performance low cost package. The device provides high robustness by supporting 20,000g shock reliability.

APPLICATIONS

• Smartphones and Tablets

• Wearable Sensors

FEATURES 

GYROSCOPE FEATURES
      The triple-axis MEMS gyroscope in the ICM-20600 includes a wide range of features:

• Digital-output X-, Y-, and Z-axis angular rate sensors (gyroscopes) with a user-programmable full-scale range of ±250, ±500, ±1000, and ±2000°/sec and integrated 16-bit ADCs

• Digitally-programmable low-pass filter

• Low-power gyroscope operation

• Factory calibrated sensitivity scale factor

• Self-test

ACCELEROMETER FEATURES
      The triple-axis MEMS accelerometer in ICM-20600 includes a wide range of features:

• Digital-output X-, Y-, and Z-axis accelerometer with a programmable full scale range of ±2g, ±4g, ±8g and ±16g and integrated 16-bit ADCs

• User-programmable interrupts

• Wake-on-motion interrupt for low power operation of applications processor

• Self-test

詳細資料，請向相關窗口索要Datasheet。